Heavy Equipment Mechanic

Overview This position is physically located in the Philippines in support of LOGCAP*** Responsibilities Inspects, tests, repair, maintain and operate various wheeled and non-wheeled equipment/vehicles, including 7-Ton Trucks, 5-Ton Trucks, back-loaders, tractors, trailers, pumps and generators to determine equipment serviceability and proper operation. Service equipment with fuel, oil, water, coolant, treats for corrosion, hydraulic fluid, refrigerant, and compressed air, disassembles and assembles malfunctioning accessories and components. Remove, disassembles, repairs, clean, treats for corrosion, assemblies and reinstalls components and accessories. Dispose of hazardous materials and waste in accordance with all state, local and federal environmental standards and regulations. Operates, cleans, inspects and services wheeled and other equipment for maintenance purposes. Practice good housekeeping, property accountability control, and safety at all times. Additional responsibilities include working with a variety of repair and test equipment including welders, torches, pressure tester and electrical tester to name a few. Performs other duties and responsibilities as assigned. Inspect, service, lubricate, adjust, and replace parts, minor assemblies, and subassemblies. This support includes operator checks and services, organic level preventive maintenance checks and service, corrective maintenance to include inspection, identification of discrepancies (fault isolation), submitting requisition requests to approval authorities, installation parts replacement, final inspections and quality control. Perform scheduled maintenance, diagnosis and isolation of previously identified and traced equipment malfunctions, replacement of major assemblies/modular components that can be readily removed/installed and do not require critical adjustment. Functional services required include but are not limited to: Automotive Maintenance and Engineering Equipment Maintenance. The HEM shall perform routine repair service that includes, but is not limited to, oil changes & lubing; tire rotation; work on brakes; suspension; heat / air conditioning systems; electrical systems; diesel engine repair; hydraulic systems, and other repairs normal and customary for maintenance of Marine Corps equipment. Extensive use of basic shop equipment, diagnostics equipment, hand tools, power tools, air tools, and lifting devices. Steel Toe shoes are required. Personal Protective Equipment (PPE) is required in certain areas while work is being conducted. Such PPE includes, but is not limited to: Face Mask, head, foot, hand, vision and hearing protective devices. Periodic use of computer systems and multi-function devices (MFD). Perform troubleshooting and diagnostics with the appropriate diagnostic equipment to identify equipment defects or issues. Identify repair/replacement parts using associated TM for requisition Utilize GCSS-A to order repair/replacement parts Document maintenance actions in GCSS-A Qualifications Local National Requirements: Education / Certifications: High school diploma or equivalent; Must possess a valid Driver’s License. Experience: Approximately five (5) years’ experience as an electrical, hydraulic, pneumatic systems maintenance mechanic, and Heavy Equipment or diesel maintenance experience; Familiarity with mechanical diagnostic equipment; At least three (3) years of experience in Automotive/General Equipment maintenance or an equivalent; A valid Driver’s License is required for all Labor Categories in the Philippines. Working Environment: Work is generally conducted in a shop environment. However, duties may involve outdoor work with potential exposure to extreme climatic condition. Work requires stooping, climbing, prolonged standing, prolonged sitting and occasional working in cramped and awkward position. Frequent exposure to inclement weather, extreme heat and cold, high/low humidity, blowing dust, and working in confined spaces and at heights. Must be willing to work additional hours when mission requires. Physical Activities: Must be able to climb up and down ladders and stairs, as well as bend, twist, and squat for prolonged periods. Must be able to pull, push and lift up to 50 pounds. Function in conditions of inclement weather, extreme heat and cold, high/low humidity, blowing sand and dust, and working in confined spaces and at heights. Senior Mid-Senior level Employment type Full-time Job function Management and Manufacturing Industries Defense and Space Manufacturing We are committed to equal employment opportunity and fostering an inclusive and diverse workplace. We strive to treat all individuals with fairness, respect, and dignity. #J-18808-Ljbffr